TOP COAT Glossy 1 litre tin

PREPARATION: (Amount of part A and part B to be mixed):

For 1000gr of part A (Topcoat) add 435gr of part B (Activator)

NB: THE KIT IS SUPPLIED WITH THESE QUANTITIES ALREADY. IN CASE OF COMPLETE USE MIX THE ENTIRE QUANTITY OF PART A AND PART B, IN CASE OF PARTIAL USE RESPECT THE RATIOS INDICATED ABOVE.

APPLICATION:

• TOPCOAT +2K must be applied after 12-24 h after applying at least 4-5 coats of Wrapper

• After mixing part A (Topcoat) and part B (Activator = hardener) according to the ratios below, filter the product before putting it into the airbrush cup or use the specific cup filters.

• Spray application with airbrush recommended for final transparencies frombodywork with nozzle 1.3 –1.5

• Media: 5 – 35 °C and always 3 °C above Dew Point Environment: Min 5 °C – Max 35 °C

• Apply 2 coats and wait about 10 minutes between each 75 microns per coat with catalysed product

• After applying the final coat, wait 15 minutes (flash-off phase) before drying in hot forced air – oven.

AIR DRYING 20*

• out of powder 30-40 minutes at the indicated thickness per coat
• out of touch 4-5 hours
• dry in depth 24 to 48 hours at the indicated thickness per coat

AIR DRYING FORCED (CABIN OVEN)

• 30-60 minutes at 60-65°C

GENERAL INFORMATION IMPORTANT

TOPCOAT +2K

• Topcoat +2k is supplied in a kit with 1 litre of part A and the required amount of part B to be mixed with the whole litre of part A. If you wish to use smaller quantities of product, respect the proportions found in the technical data sheet and mix the two products well.

• – Topcoat +2K is available in both Gloss and Matt versions and is a specific formulation for Wrapper.

• Never apply any other two-component clearcoats on Wrapper than our Topcoat +2k

• The two-component clearcoat once dry can be sanded and in the case of the glossy two-component clearcoat it can also be polished with an orbital and abrasive paste.

• To remove any orange peel after applying 2 coats of two-component gloss clearcoat, after at least 72 hours, sand down using sandpaper on a random orbital sander (hand sanding near the edges is recommended).

• The two-component 2K clearcoat is very elastic and tends to heat up a lot during polishing. Therefore, it is recommended to proceed with the following abrasive cycle: 2000/3000/4000/5000 and then polish with orbital (soft pad) and abrasive paste.

• As an alternative to the cycle described above, proceed with sanding the area to be treated with 2000 grit sandpaper to remove dirt or peelings and proceed with a third coat of +2k clearcoat. (this cycle is compatible with the two-component gloss and matt clearcoat).

REMOVAL OF WRAPPER WITH PROTECTION +2K

• Create a breaking point with a sharp object, taking care not to damage the surface underneath, lift 3/4 cm of the film and remove it by pulling as if it were a normal vinyl sticker.

• It is recommended to wait 24-48h for removal.